How to setting lcd pins to use the touch screen and the I2C communication?

the lcd is 2,4'' 320x240 tft...

if I put the pins like pag 16 on manual:

 CLK        SCL

DATA     SDA

GND      GND

with the 2 resistors, the touch doesn't go...  what else pin I must connect? and how setting it on a sketch? "sample code"

Thanks

 You also need to supply a power to Vcc pin, and also need to short the "I2C/SPI" jumper on I2C side, the screen should display it enter I2C mode when power on.